![Material extraction device of biomass power plant](http://kienkong.com/en/data/upload/202005/20200523104734_265.jpg)
Humidifying mixing conveyor for soil restoration | Sand water clutch |
Spray type humidifying mixer | Mixing conveyor for sludge |
Plate chain bucket elevator
Product overview of plate chain bucket elevator:
The plate chain bucket elevator is a lifting equipment with plate chain gravity induced discharge. Plate chain bucket elevator is suitable for vertical conveying of powdery, granular, small pieces of abrasive non abrasive materials, such as raw meal, cement, coal, limestone, dry clay, clinker, etc. The material is discharged to the top of the hopper by gravity flows into the chain elevator. Plate chain is an excellent alloy steel plate chain with high strength, wear resistance reliability. The drive part adopts hard tooth surface reducer. The hoist is suitable for vertical transportation of medium, large abrasive materials (such as limestone, cement clinker, gypsum lump coal), the material temperature is controlled below 250 ℃. Good sealing, reliable operation, less environmental pollution, convenient operation maintenance, long service life.
There are 11 types of plate chain bucket elevator: ne15, ne30, ne50, ne150, ne200, ne300, NE400, ne500, ne600, ne800.
Product features of plate chain bucket elevator:
1. There is a wide range of promotion. This kind of hoist has less requirements on the type, characteristics block size of materials. It can only improve the general powder, granular block materials, but also improve the materials with high grindability. Material temperature ≤ 250 ℃.
2. Large conveying capacity. This series of hoists have ne15-ne800 specifications. The lifting capacity ranges 15 to 800 m3 / h.
3. The driving power is small. This kind of hoist adopts inflow feeding, gravity induced discharge, adopts dense layout of large capacity hopper conveying, with low chain speed large lifting capacity. When the material is lifted, there is almost no material return digging phenomenon, so the invalid power is less, the power consumption is 70% of the ring chain hoist.
4. Long service life. The feeding of the hoist adopts the inflow type, so there is no need to dig the material with a bucket. There is little extrusion collision between the materials. The design of the hoist ensures that the materials will be scattered in the feeding, lifting discharging, which reduces the mechanical wear. The conveyor chain adopts the plate chain type high-strength wear-resistant chain, which greatly extends the service life. Under normal use, the service life of the conveyor chain is more than 5 years.
5. The lifting height is high. Therefore, it can run smoothly with 40m alloy chain plate high strength.
6. Good sealing. Less environmental pollution.
7. Good operation reliability. The advanced design principle ensures the reliability of the whole machine, the fault free time exceeds 30000 hours.
8. It is easy to operate maintain with few vulnerable parts.
9. The mechanical size is small. Compared with other kinds of hoists with the same lifting capacity, the mechanical size of this kind of hoist is smaller.
10. Structural port type, high precision. The shell has good rigidity beautiful appearance by folding middle pressing rib, then welding.
11. The use cost is low. Due to energy saving less maintenance, the use cost is very low.
Other transport equipment |
Hoist | Discharger |